RIDLEY Bicycle Bedienungshandbuch PDF herunterladen (Seite 20)

NOTE: Once the manufacturer or the dealer installs the quick

release in the hub axle, it never needs to be removed unless the hub

itself

6.1.2. Front Wheel Secondary Retention

Devices

Many bicycles have front forks that utilize a secondary wheel

retention device to keep the wheel from disengaging if the quick

release is incorrectly adjusted. Secondary retention devices are not a

substitute for correct quick release adjustment.

Secondary retention devices fall into two basic categories:

a) The clip-on type is an accessory part that the manufacturer adds

to the front wheel hub or front fork.

b) The integral type is molded, cast or machined into the outer faces

of the front fork dropouts.

Ask your dealer to explain the particular secondary retention device

on your bike.

WARNING: Removing or disabling the secondary retention device is

extremely dangerous and may lead to serious injury or death. It also

may void the warranty.

6.1.3. Removing or Installing Quick Release

Wheels

6.1.3.a. Removing a Quick Release Front Wheel

(1) Open up the brake shoes.

(2) Rotate the wheel's quick-release lever from the locked or

CLOSED position to the OPEN position (Fig.12 & 13).

(3) If your front fork does not have a secondary retention device, go

to step 5.

(4) If your front fork has a clip-on type

secondary retention device, disengage

it and go to step (5). If your front fork

has an integral secondary retention

device, loosen the tension adjusting nut

about six full turns.

(5) Raise the front wheel a few inches

off the ground and tap the top of the

wheel with the palm of your hand to

knock the wheel out of the front fork.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Keine Kommentare

RIDLEY Bicycle Bedienungshandbuch Seite 20